Kako vzdrževati ultrazvočni plastični varilni stroj?

Regarding daily cleaning and inspection, the welding head, bottom mold and workpiece need to be kept clean. After each use, use a soft cloth or special tools to clean the remaining plastic debris, dust and oil to prevent impurities from affecting welding efficiency and protect the welding head. At the same time, check the cable connector at least once a week, especially the connection between the power cord and the control line, to ensure Da je trdno in ne ohlapno, da se izognete okvari vezja . Poleg tega je treba zračni filter očistiti vsak mesec ali četrt

Glede na mehansko vzdrževanje in mazanje vsak dan obrišite površino opreme s suho mehko krpo in se izogibajte uporabi čiščenja s tekočino, da preprečite poškodbe nadzorne plošče in zaslona . hkrati, izogibajte se postavljanju težkih predmetov ali tekočih predmetov nad škatlo za oscilatorje, da preprečite, da bi se z drsnimi deli zmanjšali, kot je, da se redno maščobe mazanje in redno maščobe redno maščo nosite, vendar bodite previdni, da uporabite pravo količino, da se izognete prekomernemu onesnaževanju opreme .

Environmental management is also an important part of maintenance. The equipment should be placed in a well-ventilated environment, and the ambient temperature should be controlled below 40℃to promote heat dissipation and extend service life. When not in use, the equipment should be covered with a dust cover or dust cloth to prevent dust and debris from entering.

Obstajajo tudi nekatere operativne specifikacije in previdnostne ukrepe, ki jih je treba upoštevati . Po začetku opreme, počakajte približno 2 minuti, dokler sistem ne bo stabilen, preden ga ne uporabite, da se izognete trenutnemu toku udarcu . Če je varilna glava vroče, ga je treba takoj ustaviti in uporabljati, če se v kratkem ohladi, da se po kratkem ohladi {{3} zamenjano . Hkrati je treba zagotoviti, da je stisnjeni plin suh in čist, in redno preverjajte, ali je v filtrirni napravi . obarva

Finally, in terms of troubleshooting and parts replacement, if abnormal noise occurs during welding, it is necessary to check whether the welding head, amplifier or transducer has cracks or loose contact, and replace or tighten it in time. For non-original molds, the frequency needs to be adjusted before use, but it is prohibited to adjust the frequency at will during continuous production.